Esri ArcGIS Utility Network Associate (EUNA_2024) Certification Sample Questions

01. A telecom editor places several splitters inside a cabinet feature in the ArcGIS Utility Network, and the splitter points are not geometrically coincident with the cabinet.
Which association models the splitters being held inside the cabinet?
a) Connectivity association
b) Containment association
c) Structural attachment association

02. In an electric ArcGIS Utility Network, a single line feature is maintained to summarize the extent of each subnetwork.
What is this summarizing feature called?
a) Assembly
b) Edge object
c) SubnetLine

03. Several editors at a water utility need to edit the same ArcGIS Utility Network concurrently and later reconcile their work.
Which capability of the network's editing model supports this?
a) Branch versioning through the feature service
b) Editing a downloaded offline shapefile
c) A shared file geodatabase lock

04. An analyst changes only the subnetwork controller flag on an electric circuit but makes no connectivity edits, and the topology already shows no dirty areas.
Which operation is the appropriate next step to reflect the change?
a) Validate Network Topology
b) Update Subnetwork
c) Disable Network Topology

05. When a sewer ArcGIS Utility Network is validated, a feature is flagged because it violates a configured connectivity rule.
What is this flagged feature called?
a) Network category
b) Dirty area
c) Error feature

06. A sewer analyst must choose between an isolation trace and an upstream trace to find the maintenance-hole where a blockage would be accessed from the source side in the ArcGIS Utility Network.
Which trace returns the features between a point and its source, and why is it the right choice here?
a) Isolation trace, because it always returns the nearest maintenance-hole
b) Downstream trace, because it returns everything toward the source
c) Upstream trace, since it returns features toward the source

07. Before a subnetwork trace will return correct results in a gas ArcGIS Utility Network, the network must be in a consistent analytical state.
Which condition must be satisfied first?
a) All features have been shared as a web layer
b) The network topology is enabled and validated
c) A network diagram has been generated for the area

08. A water analyst must return only the features fed by a specific storage tank acting as a source, while a nearby tank feeds an overlapping area in the ArcGIS Utility Network.
Which approach reliably returns only the first tank's supplied features?
a) A loops trace started at the first tank
b) A connected trace started at the first tank
c) A downstream trace started at the first tank

09. In an electric ArcGIS Utility Network, a trace should stop where an open switch breaks continuity so de-energized areas are not included.
What network behavior causes the trace to stop at the open device?
a) Traversability set by network attributes and barriers
b) The map's current scale range
c) The asset type label configured for the device's symbology

10. After a large batch of edits in a water ArcGIS Utility Network, many dirty areas remain across the study area.
What is the appropriate action to make tracing reliable again?
a) Delete the dirty areas from the network
b) Run Validate Network Topology
c) Regenerate all network diagrams first